Thermal Roof Inspections
The various weather conditions in Western states can put a lot of stress on the integrity of the structure and make a small leak a big problem.
Your roof makes up about 1/3 of your building.
30% of your commercial building protects 100% of your assets
Save Money & Protect Your Investment
Drone infrared thermography roof inspection allows you to pinpoint leaks and other problem areas so you can make the best repair or replacement decisions for your situation.
Licensed ● Insured ● ITC Certified Level 3 Thermographer
Common Problems Affecting Commercial Roofs
Exposure to the sun, inclement weather, heavy winds, etc.
Structural movement (aka thermal movement)
Ponding water
Rust/corrosion (specifically on metal roofs)
Punctures, cracks, and tears (usually caused by severe weather, mechanical damage, or foot traffic)
Debris, dirt, and other surface contaminants
Biological growth
Shrinkage
Poor installation
Neglecting maintenance
Beyond a Visual Inspection
What we check during a thermal
commercial roof inspection.
The human eye is limited in what it can detect. A visual roof inspection can’t see moisture that’s begun to seep into the substrate. It can’t see thermal defects, and can’t detect hot or cold spots that can indicate a bigger problem. Thermography (also known as infrared scanning) can.
Issues a Thermography Scan Reveals
Roof drains/accumulated debris
Ponding water
Hot or cold points
Holes in the substrate
Cracks
Blisters
Uplifted seams
Uplifted nails and/or shingles
And much more
Roof Replacement Should
Be a Last Resort
Some roofers say that if more than 20% of a roof is wet or has other issues, then the entire roof must be replaced. Industry magazines report that 80% of all roofing material taken to the dump is dry.
Say you have a 100,000 Square Foot roof and only 30% needs to be replaced.
Current ballpark numbers for total roofing system replacement are about $20.00 per square foot. That is a $2 Million dollar job. If you only need to replace 30 percent of the roof, that is $600,000.
We may be able to save you a lot of money.
If your roof needs repairs instead of replacement, you are more likely to be able to address the issues more quickly.
Depending on your local building codes, a full replacement might make it necessary for you to update more than just your roof.
Some municipalities have code standards that require updating the roof insulation to current codes if you replace the entire roof.
Thus, if you have to increase the thickness of the insulation, you may have to rebuild all roof penetrations: curbing, parapets and other penetrations. That will add substantially to the cost over and above the cost of just the roof repair.
Experience & Industry Expertise You Can Depend On
Be Wary of "Free"
Many roofing companies offer free commercial roof inspections. These inspections are frequently no-obligation and give commercial roof contractors the opportunity to show building owners their expertise and value.
However, where many – if not most – contractors differ from each other is the quality of the free inspection they offer. Fly-by-night or less-than-stellar roofing companies may perform roof inspections that are quick or hardly comprehensive in order to increase their number of bids within an area or seemingly maximize their time.
Any roof inspection that is done too quickly or by someone who doesn’t have training and experience in building science can spell disaster for a building owner’s needs.
After all, if a roof’s issues or developing problems are not identified, then what will prevent those issues from arising in the short-run or long-run?
Infrared thermography roof inspection
allows you to pinpoint leaks and other problem areas so you can make the best repair or replacement decisions for your situation.
Faster (30 minutes instead of 6 hours)
Safely inspect hard-to-reach areas
Non-destructive. Core samples are only needed to verify anomalies.
A thermal imager allows us to check for saturation, moisture.
Better data. Get a clear picture of the health of your entire roof.
Plan your project accurately and save time and money.
What We Inspect
The building envelope
Exterior walls
Roof perimeter, fascia/coping
Roof surface condition, rust/corrosion, ponding water, granule loss, etc.
Penetrations (chimneys, vents, skylights, exhaust fans, etc.)
Drainage system (gutters, downspouts, scuppers, etc.)
Roof-based accessories and equipment
Flashing
Lightning protection systems
Pitch pans
Roof vents
Save Time & Money
Identify issues invisible to the naked eye that would be missed on a walk-inspection.
Repair, recoat, recover, or replace.
Pinpoint problem areas
Add years to the life of your existing roof.
What You’ll Get
Free initial consultation
Scan with an expert drone operator
Detailed report of findings compiled by skilled, experienced thermographers.
The information you need to make the smartest decision to protect your investment.
Property owners
Schools
Commercial real estate investors
Cold storage warehouses
Banks
Give us a call.
We promise to take excellent care of you.
It's easy to get started...
Just give us a call. We will set up an initial consultation and talk about your roof. The consultation is no cost, no obligation, and no pressure.